 |
||||
| Read along to find out just how easy it is to work with No More Ply tile backing board or use the link on the right to download a PDF guide to your desktop. Most computers will have Adobe Acrobat installed but if you cannot launch our guide select the Adobe logo on the right for a free download. |  |
 |
||
-------------------------------------------------------------------------------------------------------------------- |
||||
 |
|
1) No More Ply is ideal for covering dirty, cracked, worn out concrete floors. Always remove loose material, clean thoroughly and prime with 1 coat of SBR Primer (1 part SBR to 3 parts water) before laying No More Ply over concrete in order to seal in the dust and porous surface. | ||
|
||||
 |
|
2) Make sure the floor area is clean and free from any loose materials. No More Ply boards must be primed both sides with 1 coat SBR Primer (1 part SBR to 3 parts water). For best results, lay No More Ply on single, part flexible, rapid setting adhesive ensuring that all joints are staggered. | ||
|
||||
 |
|
3) For straight cuts score with the No More Ply Scoring Knife and snap the board across a length of timber or other ridge. For curves or more intricate shapes a jigsaw can be used. For working around pipes a tile nipper can also be used. Please note that the 9mm No More Ply board may need 3 or 4 scores to ensure a clean snap. |
||
|
||||
 |
|
4) When the floor is covered with No More Ply board allow the adhesive to set - please see the adhesive manufacturer’s guidelines on setting time for this. Cold or damp conditions will delay setting times. Sweep floors clean and you are ready for your tiling cement. | ||
